Tab Content
No Recent Activity
About payzahh

Basic Information

About payzahh
Location:
UK

Statistics


Total Posts
Total Posts
2
Posts Per Day
0.00
General Information
Last Activity
04-15-2017 09:34 PM
Join Date
12-07-2012
View payzahh's Blog

Recent Entries

Starting work on Necron Armies on parade piece

by payzahh on 07-05-2013 at 09:03 PM
Started buy undercoating Necron tomb citadel tile with black and white citadel spay paint, in order to get a bright green colour to take well. Used masking tape to cover the areas that I will later spray with a sepia wash.




I then used a fishing net (landing net) that had the desired weave to act as a mask, therefore leaving a repeating hexagon patern of green on black.

Read More

Updated 07-05-2013 at 09:07 PM by payzahh

Categories
Painting and Modelling , Tabletop Gaming , Warhammer 40K

Post 5: Painting and assembling the flyer

by payzahh on 02-25-2013 at 04:20 PM
Post 5: Painting and assembling the flyer


I undecorated the wings black and the chassis/cockpit cover whatever you would call it white.
I then used a sepia
wash in an air gun to create nice blend of colour on the white section. The wash used was thinned down and applied sparingly so that the overall effect was a bone colour. I then used a less thinned wash to create a colour gradient, getting darker to the outer sections.

Attachment 19138

Read More

Categories
Uncategorized

Alternative mount design for Doom scythe post 4

by payzahh on 01-05-2013 at 09:06 AM
Post 4: Finishing the base

For this post, the photo's don't realy need explaining.
I tried using weathering powders on the barrel and tank trap, as I had not used them before.







I am quite happy with the end result.
The blending of colour in the greens of the beam haven't come out at all in the photo, so perhaps they are too understated.

Read More

Categories
Uncategorized

Alternative mount design for Doom scythe post 3

by payzahh on 01-04-2013 at 04:12 PM
Post 3: Explosion and Undercoating.

Sand and stone were added with the help of some PVA, and I then modelled the explosion using green-stuff modelling clay.



Not a very technical piece of sculpting work, and not something I am good at, but fit for purpose.


Next I under-coated the base, and started thinking about the colour scheme.


Read More

Updated 01-05-2013 at 08:27 AM by payzahh

Categories
Uncategorized

Alternative mount design for Doom scythe post 2

by payzahh on 01-03-2013 at 06:24 PM
Post 2: Creating the base.

A router with a round-over edge forming bit, was used on the top side of the base.
I then used a Dremmel multi to carve out a groove, from where the rod exits the wood to the edge of the base.
This will help model the destruction caused by the passing of the "death ray"
Attachment 17925

A few inches of the rod on the end that will attach to the model, was re-shaped using a grinder.
The idea was to create an

Read More


Privacy Policy  |   Terms and Conditions  |   Contact Us  |   The Legion


Copyright © 2001-2016 CMON Inc.

-->