Article: Joint Pinning Made Easy - Page 2
Page 2 of 2 FirstFirst 12
Results 21 to 26 of 26

Thread: Article: Joint Pinning Made Easy

  1. #21


    Exactly what I needed exactly when I needed it. I am finally getting to some figs that I've been sitting on for a while and I have so much pinning to do. This officially made my life a million times easier.

  2. #22


    Excellent Idea! I was in the process of magnetizing some of my plastic miniatures to swap parts for tourney gaming and placing the magnets in exactly the right spot is the same issue as pinning hole alignment. Your solution is far superior to any I've used for lining up holes! Thanks!

  3. #23


    Elegant, simple, and it worked a treat, alleviating a few "grr" moments. Thanks.

  4. #24

    Default Article: Joint Pinning Made Easy

  5. #25


    Good tip - you can also do it the other way around, using the pinhole to indent the putty.
    Last edited by sippog; 02-28-2018 at 03:36 PM.

  6. #26


    very good, compliment

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Privacy Policy  |   Terms and Conditions  |   Contact Us  |   The Legion

Copyright © 2001-2018 CMON Inc.