Sentinel construction problem...

[DaN]

Yo peeps.

Got a sentinel for my Bday the other day, and now my eyes are OKish again I started to put it together... However, I can\'t quite see how to put on a few pieces...

1> The chainsaw blade bit

2> Which of the joints the \"different\" hubcap bits go on... (Ie. There are 4 small round discs to go on the leg joints, and 2 round discs with sticky-out bits)

Would appreciate a quick hand - Then I\'ll post the primered one in the WIP forum.
Cheers.

 

[Wolf Fang]

as you can see the 2 larger are on the \"hips\" and otehr 4 are the \"knees\"

 

[TaintedBrush]

Here\'s a tip from when I painted some for my armored company. I would reccomend painting the driver separately. You cant fit him back in with the roof glued on, so this requires painting the roof/frame aside as well.

I never used the chainsaw bit, but I would assume it goes where that lascannon is in the picture above.

 

[freakinacage]

i thought the chainsaw attacted below the cab? not entirely sure though. as t.b. said painting the driver can be a problem. i left one of the sides off when painting mine so i would paint the interior too. then, when finished i tipped a load of orange paint on it - ack

 

[DaN]

Yeah - Figured about leaving the sides off to do the interior! lol

As for the chainsaw bit - on the box it\'s shown underslung beneath the cab, but the only thing I can see to attach it to is a little dimple, which won\'t hold it in place - and I don\'t really want to glue it in place... Tbh I might just leave it off and perhaps attach something else...

I\'ve just sprayed the base, so I will get some pics for the WIP asap.

 

[Undave]

yeah unfortunately it\'s meant to be glued to the dimple under the cab. Might I recommend rare earth magnets?

 

[DaN]

Yeah - not a bad idea - I\'ve got a few of those magnets...

But to honest I don\'t wanna waste em - I think I\'ll just leave it bare or try a different weapon

Base sprayed and in the WIPs

 

[Wolf Fang]

cut off dimple drill hole drill hole in chansaw insert pin and glue