hi, just turned a ripe old age of 30 and i thought i would treat myself to a forgeworld resin giant.cleaned that sucker real good (hot soapy water) prepd with sealer and chaos black spray,result!....no. chunks of paint flaking off. any ideas of why and how to sort it out would be appreciated.
flakey paint?
- Thread starter ralfmetal
- Start date
A
Aragorns_mate
Guest
i read somwhere that you should apply a coat of \"ard coat\" vanish after cleaning the model before you prime, try that, if it works post on here so that everyone will know what to do
hope this helps
- gez
hope this helps
- gez
Drake Farstrider
New member
It could be one of a few things:
Spray can not shaken up enough. Shake the Hell out of it!
Spraying from too great a distance, you should spray from about 8-10 inches away.
Humiditly/cold, a major problem here in Seattle.
The spray paint is not up to room temperature, try soaking it in hot water.
Not letting the 1st coat of paint dry properly. Use 3-4 thin coats as opposed to 1 thick coat.
I have had the same problem in the past and these were the common problems.
I hope this may help.
Spray can not shaken up enough. Shake the Hell out of it!
Spraying from too great a distance, you should spray from about 8-10 inches away.
Humiditly/cold, a major problem here in Seattle.
The spray paint is not up to room temperature, try soaking it in hot water.
Not letting the 1st coat of paint dry properly. Use 3-4 thin coats as opposed to 1 thick coat.
I have had the same problem in the past and these were the common problems.
I hope this may help.
