mold making

[Wolf Fang]

how would one go about making a mold to make a model out of green stuff from an existing peice?

 

[green stuff]

One would look in the article section :

http://www.coolminiornot.com/article/aid/739

 

[Einion]

A whole figure might not be possible. Individual parts without a lot of undercuts, no probs but fully three-dimensional parts? Not so much.

Einion

 

[Wolf Fang]

thanks for the link to the article... its for making rippers as i dont want to pay 10$ to get a weapons sprue just for the rippers

 

[airhead]

Originally posted by Wolf Fang
thanks for the link to the article... its for making rippers as i dont want to pay 10$ to get a weapons sprue just for the rippers

You\'ll spend more than that if you want to make a decent resin cast of them. Somewhere between $20 & $40 will get you going, but you\'d be able to make a WHOLE bunch of copies that you can only use for your use.

www.smooth-on.com

 

[mickc22]

you might find something useful here

http://uk.youtube.com/watch?v=lV91nrtReRI

 

[mickc22]

actually this one is probably more useful

http://uk.youtube.com/watch?v=kRpdOkwitFE&feature=channel

it would be easier to adjust this to suit your needs, obviously with minis your only looking at grams not lbs of silicone

 

[GreenOne]

Thanks MattSterbenz for the article.
After moving,I was missing 3 shields for my mounted wight and I had a errant knight who was missing his right leg, half his sword and his head after fighting with the furry white beast of Waf... Thank to this article I could make it all right