x-mas dragon

M

minimaker

New member
http://www.creafigs.com/forums.php?m=posts&q=1131&d=325
Scroll down the page. Really cute dragon for the santa with the monsters project.
 
T

TAB Studio

New member
Oh the face is the best... I like the fact the teeth are there but no ugly tougue thing going on.
Will it ever be caste how do we find out about this?
 
A

Astonia

New member
Oooooh! I love that dragon! The face and the wings looked absolutely wonderful! I hope it will up for sale when casted :)
 
M

minimaker

New member
I just asked about reproduction of the dragon over at creafigs and got asked if I knew any available female dragons. lol

Anyway, the dragon is a hobby one-of. So I\'m afraid it will not get cast (unless some company pics up on it).
 
M

minimaker

New member
With lionman rider? :D
Pst, VIP? ;)

As to the x-mas dragon, best we could hope for is that a company like Fenryll likes it enough to use for their series. Hmm, should we drop a subtle hint there?
 
L

LavronYor

Member
Or a not so subtle hint. That is one cool dragon. I wish I had one protecting my minis. Uhhh, I\'m with Trevor on the gimp, that was disturbing. His comment was LOL funny though.
 
green stuff

green stuff

Active member
Message original : minimaker
With lionman rider? :D
Pst, VIP? ;)

As to the x-mas dragon, best we could hope for is that a company like Fenryll likes it enough to use for their series. Hmm, should we drop a subtle hint there?
Click to expand...
Actually, I thought the lionman might look better on a manticora or a sphinx.

How can one cast the ribbon?

Did I miss out on a dragon sculpting VIP, or is that the current subject?

Here\'s an idea, what if all you fine folks headed off to the current sculpt project thread and told all of the sculptors to hurry up and finish the cyber-angel design? We could then start sculpt project n°2, a.k.a. : code dragon ;). They\'re going to hate me over there ;).
 
K

kittykat23uk

New member
@Minimaker, could it be cast though? I mean, it looks like its a one piece, made in sculpey, so I\'m guessing there may well be casting issues with it. Its a real pitty though, becazuse it is quite unusual!

@Greenstuff, I like the idea of a dragon mini as the next sculpting project and I also really liked the idea of the lionman too. But the rate I\'m getting on with the VIP thats currently running I\'d probably just end up holding things up! :rolleyes:

Regards

Kat
 
M

minimaker

New member
Many questions.

Casting the x-mas dragon. I\'d guess it can actually be cast. Multi-part. I just had a look at the bow and when cast separatly I don\'t think it should be a problem. As to the use of FIMO, well, that\'s why I was thinking of Fenryll. French companies like Fenryll, Illyad and Rackham are used to FIMO masters. The other reason is that Fenryll is the only company I can think of where a figure like this would fit in the range.
One thing not yet mentioned is that the dragon is fairly bit, about 20cm (8\"). Quite an investment for a company.
Now, how to go about dropping hints?

VIP: there is a list on site where you can drop suggestions. Not a dragon on it yet. :) As to the current subject: \"things that go bump in the night\".

Current sculpting project. Go ahead and hop over to give your opinions. :D
 
You must log in or register to reply here.
Back To Top
Top